User guide

Advanced Programming 9-21
89. From the Run menu, select Dry Run.
> Make certain that the program executes the following steps correctly:
• Finds two corner fiducials on the workpiece.
• Finds the fiducials at each flip chip model location for the U-pass
pattern.
• Perform a Flow Rate measurement. (Only performed on Wet Run.)
• Performs a substrate height measurement.
• Dry dispenses two lines around each of the four flip chip models.
• Waits for the timer to expire, then dry dispenses a single U-shaped line
around the four flip chip models.
90. When satisfied that the program executes correctly, select Wet Run from the Run
menu.
This concludes the tutorial on a U-shaped Multipass Workpiece.