User guide

Beginning Programming 8-23
9. Click on Done.
10. Select Dry Run from the Run menu.
> Watch to see the camera move across the rectangular pattern.
The dispensing head will move after your response.
If you get an error message that the speed is too slow, re-check your dot
parameters and try again.
11. Select Wet Run from the Run menu.
> Watch as the Area Fill dispenses.
> Examine the board for quality and accuracy.
Figure 8-5
Figure 8-6
This concludes the tutorial on Area Fill.
Spacing
between lines
Corner 1
Corner 2
Customized
Dialogs for
Area/Spiral fill
Weight-control
Lines