User guide

Beginning Programming 8-5
Editing the Lines
If you were not satisfied with the lines dispensed, you can simply edit them. This exercise will
teach you how to edit existing lines in a program. For this exercise, you will shift the lines
over and shorten them.
To edit the lines (shift them over and shorten):
1. From the Edit menu in the Programming Window, select Edit Pattern.
2. Click on Workpiece.
The dispensing head will move after your response.
3. Place the cursor on 1 LINE in the program and double-click.
> A Teach Window opens.
4. Use the Position Controls to move the crosshairs to the start of the first shorter line
in the set of shorter lines on the Tutorial Board.
5. Click on Teach.
6. Use the Position Controls to move the crosshairs to the end point of the next line.
7. Click on Teach.
8. Repeat Steps 3 - 7 for the other two lines.
9. Click on Done.
10. Select Dry Run from the Run menu.
The dispensing head will move after your response.
> Watch to see the program run with the lines shifted over and shortened.
11. Select Wet Run from the Run menu.
> Watch as the lines are dispensed.
> Examine the board for quality and accuracy.
This concludes the tutorial on Editing Basic Lines.