User guide

7-16 Programming Basics
When using a single fiducial with Orthogonality Tolerance, FMW calculates the angle of the
corner defined by the calipers. If the corner is within the Orthogonality Tolerance, the part is
considered square and dispensing on the part will be performed. For example, if the
Orthogonality Tolerance is set at 5, and the corner fiducial is determined to be 85-95 degrees,
FMW considers the part to be square. However, if the corner fiducial is less than 85 degrees
or more than 95 degrees, FMW will issue an Orthogonality Tolerance warning and you can
choose to skip the part or redefine the fiducial.
Figure 7 -4
Figure 7 -5
Projection Length
Application Point
Multiple Calipers
Search Length
Caliper