Manual

40
TFTP root folder: Specifies the folder on the ASUSTOR NAS that TFTP clients can access.
TFTP client permission: Specifies the permissions for TFTP clients. If you select “Read Only”,
TFTP clients will only be able to view the contents of the TFTP root folder. If you select “Read &
Write”, TFTP clients will be able to modify the contents of the TFTP root folder.
Client connections allowed: Selecting “All Connections”, will allow all TFTP clients to connect to
the NAS. You can also choose to limit connections to TFTP clients from a specified range of IP
addresses.
Timeout: Here you can specify the timeout time which is used to terminate idle connections,
providing an additional later of security.
SNMP
Enabling SNMP allows users to use network management software to monitor the status of their
ASUSTOR NAS.
SNMP trap level: Here, you can configure SNMP trap to actively provide warning messages.
Warning event types include: Critical, Error, Warning and Information
Trap Address: After configuring the SNMP trap level please input the IP address of the network
management station (NMS) here.
SNMP V1 / SNMP V2 service: Selecting this checkbox will enable SNMP V1 / V2 service.
Community: Enter a community name here. Community names must include 1 to 64 displayable
characters and may not include the following characters: “ ‘ \ and blank spaces.
SNMP V3 service: Selecting this checkbox will enable SNMP V3 service.
Username: Please input the SNMP V3 username here. This username must include 1 to 64
displayable characters and may not include the following characters: “ ‘ \ and blank spaces.