Installation Manual

Note: Please insert the hard disk into the HDD 1 slot shown in the graphic in order to have it

initialized.

4. Secure each hard disk with the screws provided as shown in the graphic below.

For 3.5” drives with 3 screw holes on each side.

 AS1002T / AS1002T v2

Note: If you wish to utilize the RAID function, it is recommended that you use hard disks of the same

capacity in order to fully utilize the capacity of all hard disks.

 AS1004T / AS1004T v2

Note: If you wish to utilize the RAID function, it is recommended that you use hard disks of the same

capacity in order to fully utilize the capacity of all hard disks.

For 3.5” drives with 2 screw holes on each side.

 AS1002T / AS1002T v2