User Guide

65

If you are using a Seagate IronWolf or IronWolf Pro series hard disk with a capacity of over or
equal to 4TB, you only need to navigate to [Storage Manager] → [Disk] → [Disk Doctor] and
the [IronWolf Health Management] window will appear. You can use this function to
schedule or immediately carry out a scan.

After using IronWolf Health Management to scan your hard disks, the results will either be
shown as “healthy” or a numerical output code. Please see the chart below to see the
suggestions represented by the codes.
Output Codes
from IronWolf
Health
Management
IronWolf Health Test
Result
Suggestion
100
Notification
Abnormally high operating temperature has been
detected. Please ensure rear ventilation ports are not
blocked, and try to lower the ambient temperature.
Alternatively, go to Settings > Hardware > Fan
Control to increase fan speed. If issue persists, please
contact the ASUSTOR Support Team.
101
Notification
Connection issue on your ASUSTOR NAS and hard
drive interface has been detected. Please ensure the
hard drive is properly installed in the chassis or drive
tray, and that the tray is properly installed in your
ASUSTOR NAS. If issue persists, please contact the
ASUSTOR Support Team.
102
Notification
Excessive physical shock to the hard drive has been
detected. Please ensure your hard drive and
ASUSTOR NAS are placed on a stable surface. If issue
persists, please contact the ASUSTOR Support Team.