User Guide

24
DHCP Server Settings：
You can configure the DHCP settings only if the IP address was configured manually.

Lease time (hr): Enter a value (1-720) to set the DHCP lease time (in hours) for IP addresses
assigned to DHCP clients.

Primary/Secondary DNS: Enter the Primary/Secondary DNS address for DHCP clients.

Domain Name: Set the domain name for the DHCP server.

Subnet List: You can add subnets here.

DHCP Client List: Here you can check the list of DHCP clients and their network configurations
(e.g. MAC address, IP address, hostname, and the amount of time left before the DHCP lease
expires).

DHCP Reservations: If you want a client to always receive the same IP address during DHCP
lease renewal, you can add the client to the DHCP reservation list.
PPPoE：
If you are using DSL or a cable modem to connect to the Internet and your Internet service
provider uses PPPoE (Point to Point Protocol over Ethernet), you can go to [Settings] >
[Network] > [PPPoE] and enter your account information to allow the system to connect to the
Internet without having to go through a router. If you wish to get more information about
PPPoE, please contact your Internet service provider or network administrator.
(3)Proxy：
Here you can enable proxy server connections, allowing the NAS to connect to the internet via a
proxy server.

Proxy Server: The address of the proxy server you wish to connect to. (Supports HTTP and
HTTPS)

Port: The communications port of the proxy server.

Authentication: If the proxy server you are using requires authentication, you can enable it
here and then enter your username and password.