Installation Manual

To install a 2½ " hard drive, please remove the two rails on both sides of the hard drive tray. Align the hard drive

with the 4 holes labeled 2.5" with the SATA connector facing outward. While maintaining a grip on the hard

drive and tray, turn the tray upside down and secure the drive with four included M3 screws as demonstrated

below.

4. Slide the disk tray onto the rails of the disk bay. Using the latch, gently push the disk tray all the way into the disk bay.

Secure the disk tray in place by pushing down on the latch. The latch should close easily and snap in with an audible

‘click’. Please make sure that the disk tray is pushed all the way into the disk bay before attempting to secure the

latch.

AS3302T

AS3304T

5. Return the front panel.