User Guide E11572
First Edition/ April 2016 Model: ASUS_Z016D (ZS570KL) Before you start, ensure that you have read all the safety information and operating instructions in this User Guide to prevent injury or damage to your device. NOTE: For the latest updates and more detailed information, please visit www.asus.com.
Side features Audio jack Microphone Micro SIM, nano SIM/ microSD combo card slot Volume key Power key Microphone USB Type-C port Speaker NOTES: • • The micro SIM card slot supports GSM/ GPRS/EDGE, WCDMA/HSPA+/DC-HSPA+, TD-SCDMA, CDMA2000, FDD-LTE, and TDLTE DSDS network bands. The microSD card slot supports microSD and microSDHC card formats.
Rear features Camera flash Rear camera IR sensor Fingerprint sensor Rear cover
Charging your ASUS Phone To charge your ASUS Phone: 1. Connect the USB connector into the power adapter’s USB port. 2. Connect the other end of the USB Type-C cable to your ASUS Phone. 3. Plug the power adapter into a wall socket. 3 2 1 IMPORTANT! • When using your ASUS Phone while it is plugged to a power outlet, the grounded power outlet must be near to the unit and easily accessible.
Installing a micro SIM/ nano SIM/ microSD card To install a micro SIM/ nano SIM/ microSD card: 1. Push a pin into the hole on the micro SIM/ nano SIM/ microSD card slot to eject the tray out. 2. Insert the micro SIM card into the micro SIM card slot. 3A. Insert the microSD card into the nano SIM/microSD combo card slot. IMPORTANT! You can only use the nano SIM card or the microSD card at a time.
3B. Insert the nano SIM card into the nano SIM/microSD combo card slot. 4. Push the tray to close it. CAUTION! • Do not use sharp tools or solvent on your device to avoid scratches on it. • Use only a standard micro SIM card on your ASUS Phone. A nano to micro SIM adapter or a trimmed SIM card may not properly fit into and may not be detected by your ASUS Phone. DO NOT install an empty nano to micro SIM adapter into the micro SIM card slot to avoid irreversible damage.
Federal Communications Commission Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user‘s authority to operate the equipment.
The country code selection is for non-US model only and is not available to all US model. Per FCC regulation, all WiFi product marketed in US must fixed to US operation channels only. Hearing Aid Compatibility Information (HAC) Your phone is compliant with the FCC Hearing Aid Compatibility requirements. The FCC has adopted HAC rules for digital wireless phones. These rules require certain phone to be tested and rated under the American National Standard Institute (ANSI) C63.
degree of your hearing loss. If your hearing device happens to be vulnerable to interference, you may not be able to use a rated phone successfully. Trying out the phone with your hearing device is the best way to evaluate it for your personal needs. This phone has been tested and rated for use with hearing aids for some of the wireless technologies that it uses. However, there may be some newer wireless technologies used in this phone that have not been tested yet for use with hearing aids.
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement. Radio Frequency (RF) Exposure Information The radiated output power of the Wireless Device is below the Industry Canada (IC) radio frequency exposure limits. The Wireless Device should be used in such a manner such that the potential for human contact during normal operation is minimized.
http://www.ic.gc.ca/app/sitt/reltel/srch/nwRdSrch. do?lang=eng Pour des informations supplémentaires concernant l’exposition aux RF au Canada rendez-vous sur: http://www.ic.gc.ca/eic/site/smt-gst.nsf/eng/sf08792. html Caution (i) the device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems; (ii) High-power radars are allocated as primary users (i.e.
located or operating in conjunction with any other antenna or transmitter, except tested built-in radios. The County Code Selection feature is disabled for products marketed in the US/ Canada. Cet appareil et son antenne ne doivent pas être situés ou fonctionner en conjonction avec une autre antenne ou un autre émetteur, exception faites des radios intégrées qui ont été testées. La fonction de sélection de l’indicatif du pays est désactivée pour les produits commercialisés aux États-Unis et au Canada.
has not been tested or certified, and use such accessories should be avoided. The highest FCC SAR values for the device are as follows: • 0.97 W/Kg (Head) • 1.19 W/Kg (Body-worn) The FCC has granted an Equipment Authorization for this device with all reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this device is on file with the FCC and can be found under the Display Grant section of www.fcc.gov/oet/ea/fccid after searching on FCC ID: MSQZ016D.
Radio and Telecommunications Equipment and mutual recognition of conformity.The highest CE SAR values for the device are as follows: • 0.xxx W/Kg (Head) • 0.xxx W/Kg (Body) This device is restricted for indoor use only when operating under 5150 MHz to 5350 MHz of frequency range.
Prevention of Hearing Loss To prevent possible hearing damage, do not listen at high volume levels for long periods. For France, headphones/earphones for this device are compliant with the sound pressure level requirement laid down in the applicable EN 503321:2013 and/or EN50332-2:2013 standard required by French Article L.5232-1.
• Avoid charging in extremely high or low temperature. The battery performs optimally in an ambient temperature of +5 °C to +35 °C. • Do not remove and replace the battery with a non-approved battery. • Do not remove and soak the battery in water or any other liquid. • Never try to open the battery as it contains substances that might be harmful if swallowed or allowed to come into contact with unprotected skin. • Do not remove and short-circuit the battery, as it may overheat and cause a fire.
• Do not use the ASUS Phone in an extreme environment where high temperature or high humidity exists. The ASUS Phone performs optimally in an ambient temperature between 0 °C (32 °F) and 35 °C (95 °F). • Do not disassemble the ASUS Phone or its accessories. If service or repair is required, return the unit to an authorized service center. If the unit is disassembled, a risk of electric shock or fire may result. • Do not short-circuit the battery terminals with metal items.
Proper disposal Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions. DO NOT throw the battery in municipal waste. The symbol of the crossed out wheeled bin indicates that the battery should not be placed in municipal waste. DO NOT throw this product in municipal waste. This product has been designed to enable proper reuse of parts and recycling.
ASUS Address: 4F, 150 Li-Te Road, Peitou, Taipei, Taiwan Tel: 886228943447 Fax: 886228907698 Declaration We declare that the IMEI codes for this product, ASUS Phone, are unique to each unit and only assigned to this model. The IMEI of each unit is factory set and cannot be altered by the user and that it complies with the relevant IMEI integrity related requirements expressed in the GSM standards. Should you have any questions or comments regarding this matter, please contact us.
