User Guide E12014
Third Edition/ September 2016 Model:ASUS_X014D (ZB452KG) Before you start, ensure that you have read all the safety information and operating instructions in this User Guide to prevent injury or damage to your device. NOTE: For the latest updates and more detailed information, please visit www.asus.com.
Side features Audio jack Microphone Power Key Groove Microphone Micro USB port NOTE: Pry open the rear cover from the groove.
Rear features Rear camera Camera flash Volume key Rear cover Speaker NOTES: • Remove the rear cover to display the dual micro SIM and microSD card slots. • The micro SIM card slots support, WCDMA, and GSM/EDGE network bands. The microSD card slot supports microSD and microSDHC card formats.
Charging your ASUS Phone To charge your ASUS Phone: 1. Connect the USB connector into the power adapter’s USB port. 2. Connect the other end of the micro USB cable to your ASUS Phone. 3. Plug the power adapter into a wall socket. IMPORTANT! • When using your ASUS Phone while it is plugged to a power outlet, the grounded power outlet must be near to the unit and easily accessible. • When charging your ASUS Phone through your computer, ensure that you plug the micro USB cable to your computer’s USB 2.
Installing a micro SIM card To install a micro SIM card: 1. Locate the groove on the bottom-right corner of your ASUS Phone. 2. Pry the cover loose and then pull the rear cover off. 3. Insert the micro SIM card into one of the micro SIM card slots.
IMPORTANT: Both micro SIM card slots support 3G / 2G WCDMA network band. But only one micro SIM card can connect to 3G WCDMA service at a time. CAUTION! • Do not use sharp tools or solvent on your device to avoid scratches on it. • Use only a standard micro SIM card on your ASUS Phone. A nano to micro SIM adapter or a trimmed SIM card may not properly fit into and may not be detected by your ASUS Phone.
2. Pry the cover loose and then pull the rear cover off. 3. Insert the microSD card into the microSD card slot.
Federal Communications Commission (FCC) Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
RF Exposure Information (SAR) This device has been tested and meets applicable limits for Radio Frequency (RF) exposure. Specific Absorption Rate (SAR) refers to the rate at which the body absorbs RF energy. SAR limits are 1.6 Watts per kilogram (over a volume containing a mass of 1 gram of tissue) in countries that follow the United States FCC limit and 2.0 W/kg (averaged over 10 grams of tissue) in countries that follow the Council of the European Union limit.
CE RF Exposure Compliance This device meets the EU requirements (1999/519/EC) on the limitation of exposure of the general public to electromagnetic fields by way of health protection. For body-worn operation, this device has been tested and meets the ICNIRP guidelines and the European Standard EN 62209-2, for use with dedicated accessories. SAR is measured with this device at a separation of 1.
• For first-time use of a GPS-enabled app on your device, ensure that you are outdoors to get the best positioning data. • When using a GPS-enabled app on your device inside a vehicle, the metallic component of the car window and other electronic devices might affect the GPS performance. Prevention of Hearing Loss To prevent possible hearing damage, do not listen at high volume levels for long periods.
• Avoid charging in extremely high or low temperature. The battery performs optimally in an ambient temperature of +5 °C to +35 °C. • Use only ASUS battery. Using a different battery may cause physical harm/injury and may damage your device. • Do not remove and soak the battery in water or any other liquid. • Never try to open the battery as it contains substances that might be harmful if swallowed or allowed to come into contact with unprotected skin.
• Do not use the ASUS Phone in an extreme environment where high temperature or high humidity exists. The ASUS Phone performs optimally in an ambient temperature between 0 °C (32 °F) and 35 °C (95 °F). • Do not disassemble the ASUS Phone or its accessories. If service or repair is required, return the unit to an authorized service center. If the unit is disassembled, a risk of electric shock or fire may result. • Do not short-circuit the battery terminals with metal items.
Proper disposal Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions. DO NOT throw the battery in municipal waste. The symbol of the crossed out wheeled bin indicates that the battery should not be placed in municipal waste. DO NOT throw this product in municipal waste. This product has been designed to enable proper reuse of parts and recycling.
EU Declaration of Conformity We, the undersigned, Manufacturer: ASUSTeK COMPUTER INC. Address: 4F, No. 150, LI-TE Rd., PEITOU, TAIPEI 112, TAIWAN Authorized representative in Europe: ASUS COMPUTER GmbH Address, City: HARKORT STR.
Declaraţie de conformitate UE Subsemnatul, Producător : ASUSTeK COMPUTER INC. Adresă: 4F, No. 150, LI-TE Rd., PEITOU, TAIPEI 112, TAIWAN Reprezentant autorizat în Europa: ASUS COMPUTER GmbH Adresă, Oraş: HARKORT STR.
UE Declaración de Conformidad Nosotros, los abajo firmantes, Fabricante: ASUSTeK COMPUTER INC. Dirección: 4F, No. 150, LI-TE Rd., PEITOU, TAIPEI 112, TAIWAN Representante autorizado en Europa: ASUS COMPUTER GmbH Dirección, Ciudad: HARKORT STR.
ASUS Address: 4F, No.150 Li-Te Rd., Peitou, Taipei, Taiwan Tel: 886228943447 Fax: 886228907698 Declaration We declare that the IMEI codes for this product, ASUS Phone, are unique to each unit and only assigned to this model. The IMEI of each unit is factory set and cannot be altered by the user and that it complies with the relevant IMEI integrity related requirements expressed in the GSM standards. Should you have any questions or comments regarding this matter, please contact us.
