User's Manual

WL-600g All-in-1 Wireless ADSL2/2+ Home Gateway User Manual
26
3. Set the
WPA2 Preauthentication
to
Enabled
if you want to use this function.
4. The
Network Re-auth Interval
is 36000 seconds by default, you can setup this
value according to your network environment.
5. Set up RADIUS server inforamtion by inputting WPA Group Rekey Interval,
RADIUS server IP address, RADIUS port and RADIUS Key.
6. Set up WPA encryption methods. If there are only WPA2 clients within your network,
select AES, if WPA clients only, select TKIP; if both exist, select TKIP+AES.
7. You can also enable WEP client to access your wireless network. To enable WEP
clients, set
WEP Encryption
to
Enabled
. Select 64-bit or 128-bit
Encryption
Strength
for key length then click
Set Encryption Keys
button to setup the keys.
Refer to
Open
PRGH6WHSIRUNH\FRQÀJXUDWLRQ
8. Press
Save/Apply
to save and activate the settings.
WPA-PSK
1. Click
Wireless -> Security
LQWKHOHIWVLGHPHQXWRRSHQWKHFRQÀJXUDWLRQSDJH
2. Select
WPA-PSK
in the
Network Authentication
ÀHOG
3. Input the WPA Pre-Shared Key. The key is masked by the system. To check the
key, press
Save/Apply
and wait until the page refreshes. Then click
Click here to
display
link, you can see the key displayed in a separate window.
4. Setup the WPA Group Rekey Interval.
5. Set up WPA encryption methods. If there are only WPA2 clients within your network,
select AES, if WPA clients only, select TKIP; if both exist, select TKIP+AES.
6. You can also enable WEP client to access your wireless network. To enable WEP
clients, set
WEP Encryption
to
Enabled
. Select 64-bit or 128-bit
Encryption
Strength
for key length then click
Set Encryption Keys
button to setup the keys.
Refer to
Open
PRGH6WHSIRUNH\FRQÀJXUDWLRQ
7. Press
Save/Apply
to save and activate the settings.