User's Manual

WL-600g All-in-1 Wireless ADSL2/2+ Home Gateway User Manual
8
Before you start
Before you start, you need to:
• make sure the cable connections are correct and WL-600g is powered ON;
• acquire an active Internet service, such as an ADSL account.
:HUHFRPPHQGXVLQJZLUHGFRQQHFWLRQIRULQLWLDOFRQÀJXUDWLRQZKLFKPD\
help avoid possible setup problems due to wireless uncertainty. Use a CAT5
cable to connect an Ethernet-enabled computer to a LAN port of WL-600g.
Preparing your WAN
Depending on your ISP's requirements, you may need to acquire some of the
information listed below to set up Internet connection on WL-600g.
• Vitual Path Identifier (VPI)
• Virtual Channel Identifier (VCI)
• Host name
• Domain name
• ISP login user name and password
• ISP Domain Name System (DNS) server address
• Static IP address (For static IP users)
Preparing your LAN
To use the WL-600g Wireless ADSL2/2+ Home Gateway on your network, you need to install
a network interface card (NIC) or an IEEE802.11b/g wireless network card to your computer.
/$1FRQÀJXUDWLRQUHTXLUHPHQW
)RULQLWLDOFRQÀJXUDWLRQZHUHFRPPHQG\RXWRFRQQHFWDFRPSXWHUWRRQHRIWKH/$1
SRUW RI :/J DQG FRQÀJXUH WKH7&3,3 VHWWLQJV RI \RXU FRPSXWHU 7KH GHIDXOW ,3
settings of WL-600g are:
IP address: 192.168.1.1
Subnet mask: 255.255.255.0
DHCP server: enabled
To access WL-600g, you must set your computer in the same subnet with the ADSL
router. You can make the computer accept a dynamic IP address assigned by the
DHCP server of WL-600g, or manually set up IP address for your computer.
Connecting to the Internet