User's Manual

5
Teleadapt DeskBridge Configuration
To access the DeskBridge configuration screen follow the steps below:
1. Connect the DeskBridge to your PC's Ethernet port
2. Set your PC's "Network Connection" properties for manual DHCP; as follows
a. Click the Start button and select Control Panel
b. Double click the Network Connections
c. Highlight the Local Area Connection icon and right click Properties
d. Highlight Internet Protocol (TCP/IP) and click the Properties button
e. Click the Use the following IP address button.
f. Enter IP address: 192.168.1.2
g. Enter Subnet mask: 255.255.255.0
h. Enter Default gateway: 192.168.1.1
i. Click the OK button.
j. Click the OK button again and close the Network Connections window
3. Launch your web browser and open the DeskBridge Simple Setup web interface
page at URL: http://192.168.1.10
4. Enter User ID: taclient and Password: c289x
5. Click Apply when done. Click Restore to load the default values
Note: You may also press the reset button of the DeskBridge for more than 5 seconds to
load the default values.