User's Manual

Safety Statements

Regulatory Information/Disclaimers

Installation and use of this Wireless LAN device must be in strict accordance with the

instructions included in the user documentation provided with the product. Any changes or

modifications (including the antennas) made to this device that are not expressly approved

by the manufacturer may void the user’s authority to operate the equipment. The

manufacturer is not responsible for any radio or television interference caused by

unauthorized modification of this device, or the substitution of the connecting cables and

equipment other than manufacturer specified. It is the responsibility of the user to correct any

interference caused by such unauthorized modification, substitution or attachment.

Manufacturer and its authorized resellers or distributors will assume no liability for any

damage or violation of government regulations arising from failing to comply with these

guidelines.

Safety Information

In order to maintain compliance with the FCC RF exposure guidelines, this equipment should

be installed and operated with minimum distance [20cm] between the radiator and your body.

Use only with supplied antenna.

Unauthorized antenna, modification, or attachments could damage the transmitter and may

violate FCC regulations.

MPE Statement

Your device contains a low power transmitter. When device is transmitted it sends out Radio

Frequency (RF) signal.

Prohibition of Co-location

This device and its antenna(s) must not be co-located or operating in conjunction with any other

antenna or transmitter

Caution Statement of the FCC Radio Frequency Exposure

This Wireless LAN radio device has been evaluated under FCC Bulletin OET 65C and found

compliant to the requirements as set forth in CFR 47 Sections 2.1091, 2.1093, and

15.247(b)(4) addressing RF Exposure from radio frequency devices. The radiation output

power of this Wireless LAN device is far below the FCC radio frequency exposure limits.

Nevertheless, this device shall be used in such a manner that the potential for human contact

during normal operation – as a mobile or portable device but use in a body-worn way is

strictly prohibit. When using this device, a certain separation distance between antenna and

nearby persons has to be kept to ensure RF exposure compliance. In order to comply with

the RF exposure limits established in the ANSI C95.1 standards, the distance between the

antennas and the user should not be less than [20cm].