User's Manual

5. Troubleshooting
46 ASUS SpaceLink 802.11g Access Point
Chapter 5 -Troubleshooting
Problem
The SpaceLink Access Point Manager still cannot find or connect
to the SpaceLink Access Point after verifying the IP address and
LAN cable, changes cannot be made, or password is lost.
Solution
In case the SpaceLink Access Point is inaccessible, you can
restore the SpaceLink Access Point’s factory default settings.
Use a straightened paper clip to press the button located in
the hole labeled “Reset” on the back of the SpaceLink Access
Point and keep it depressed over 5 seconds. The amber power
LED will darken and then light up when reset is successful.
Reset to Defaults
The following are factory default values. These values will be present when you
first receive your SpaceLink Access Point, if you push the reset button on the
back of the SpaceLink Access Point over 5 seconds, or if you click the “Reset to
Defaults” on the “General” page of the SpaceLink Access Point Manager.
Name Default Value
Password “asus”
IP address assignment obtain an IP address automatically
Primary port Ethernet
IP address 192.168.39.130
Subnet mask 255.255.255.0
Gateway 0.0.0.0
SSID “default”
Channel 1
WEP type WEP disable
AP name “ASUS AP”
Operational mode AP mode
Only allow IP packets Disable
Authorization table Disable
Host AP / Wireless Bridge MAC Add. 00-00-00-00-00-00
Fragmentation threshold 2346
RTS threshold 2346
Preamble mode Long preamble
Authentication type Both