RC BLUETOOTH
Notices Federal Communications Commission Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: • • This device may not cause harmful interference, and This device must accept any interference received including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
RF exposure warning This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provide with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance.
Wireless Operation Channel for Different Domains N. America 2.412-2.462 GHz Ch01 through CH11 Japan 2.412-2.484 GHz Ch01 through Ch14 Europe ETSI 2.412-2.472 GHz Ch01 through Ch13 France Restricted Wireless Frequency Bands Some areas of France have a restricted frequency band. The worst case maximum authorized power indoors are: • • 10mW for the entire 2.4 GHz band (2400 MHz–2483.5 MHz) 100mW for frequencies between 2446.5 MHz and 2483.
Canadian Department of Communications Statement This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications. This class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe [B] est conforme à la norme NMB-003 du Canada.
Safety information Electrical safety • • • • • • • To prevent electrical shock hazard, disconnect the power cable from the electrical outlet before relocating the system. When adding or removing devices to or from the system, ensure that the power cables for the devices are unplugged before the signal cables are connected. If possible, disconnect all power cables from the existing system before you add a device.
Operation safety • • • • Before installing the motherboard and adding devices on it, carefully read all the manuals that came with the package. Before using the product, ensure all cables are correctly connected and the power cables are not damaged. If you detect any damage, contact your dealer immediately. To avoid short circuits, keep paper clips, screws, and staples away from connectors, slots, sockets and circuitry. Avoid dust, humidity, and temperature extremes.
RC Bluetooth card specifications summary Product Name Bluetooth Module Model Name RC BLUETOOTH Standard Bluetooth V2.0/V2.1+EDR Frequency Band 2.402GHz—2.480GHz unlicensed ISM band Modulation Method GFSK for 1Mbps; Π/4-DQPSK for 2Mbps; 8-DPSK for 3Mbps Spread Spectrum FHSS (Frequency Hopping Spread Spectrum) Transfer rates (Max) Max UART baud rates of 3Mbps RF Output Power RF Output Power RF terminal 50 Ohms DC power DC 3.3V Dimension 5.15CM x 3.
RC Bluetooth card layout 3 1 2 1. Antenna: Receives the Bluetooth signal. The plastic cap on the antenna protects it from possible damage. 2. Bluetooth Switch: Toggles the RC Bluetooth function ON and OFF. When the RC Bluetooth is OFF, the normal Bluetooth connection is still available. 3. Bluetooth Connector: Connects the RC_BLUETOOTH connector on the motherboard.
RC Bluetooth card installation 1. Locate the RC_Bluetooth connector on the motherboard. 2. Orient the RC_Bluetooth card and firmly install it to the connector. 3. Install the Bluetooth driver from the motherboard support DVD to start using Bluetooth function.
