User's Manual

Wi2Wi, Inc. Doc No. AST-PDT-DOC Rev.1.1

Data Sheet, WLAN-Bluetooth SiP– W2CBW003

Dated: October 20, 2006

The content of this document is to be treated as strictly confidential and is not to be disclosed,

reproduced or used, except as authorized in writing by Wi2Wi, Inc.

Page 4 of 19

2 Scope

This specification provides a general guideline on the performance and the integration of Wi2Wi’s

802.11b/g + Bluetooth System in Package (SiP) Solution. The SiP, P/N W2CBW003, is targeted to

assist companies to easily integrate both WLAN and Bluetooth functionally into their products. This is

accomplished by reducing their development times and cost by using a complete, small form factor, low

power, ready to integrate Radio System Solution.

The specification maximum and minimum limits presented herein are those guaranteed when the unit is

integrated into the Wi2Wi’s W2CBW003-DEV Development System. These limits are to serve as the

representative performance characteristics of the W2CBW003 when properly designed into a customer’s

product. Wi2Wi makes no warranty, implied or otherwise specified, with respect to a customers design

and the performance characteristics presented in this specification.

The latest revision of this document supersedes all previous versions of this document. Wi2Wi reserves

the right to change this specification without notice.

3 General Features

x Compact design for easy integration: 12mm x 12mm x 1.4mm

x System-in-Package LGA with 100 pins

x WLAN technology based on Marvell’s 88W8686

x Bluetooth technology based on CSR BC04-ROM

x Certified dual mode radio

x Optimized RF and electrical design for better performance in co-existence with other wireless

standards

x Dual-antenna design with separate antennae for Bluetooth and WLAN

x Operates in 2.4GHz ISM band

x ROHS Compliant

x Single supply of 3.3V

x Fully integrated coexistence solution

x WLAN Specific Features

o SDIO 1.1 and G-SPI interfaces

o Programmable GPIOs for applications

o 50-Ohm antenna launch

o Support for WinCE and Linux (can be ported to other operating systems)

o 1, 2, 5.5 and 11 Mbps data rates for 802.11b (DSSS/CCK modulation)

o 6, 9, 12, 18, 24, 36, 48 and 54 Mpbs data rates for 802.11g (OFDM modulation)

x Bluetooth Specific Features

o UART, USB, PCM audio interfaces

o SPI interface for integration, test and diagnostics