User's Manual

Appendix A

Federal Communications Commission Statement

This device complies with FCC Rules Part 15. Operation is subject to the following two

conditions:

• This device may not cause harmful interference, and

• This device must accept any interference received, including interference that may cause

undesired operation.

This equipment has been tested and found to comply with the limits for a class B digital device,

pursuant to Part 15 of the Federal Communications Commission (FCC) rules. These limits are

designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses, and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV technician for help.

WARNING! The use of a shielded-type power cord is required in order to meet FCC emission limits and

to prevent interference to the nearby radio and television reception. It is essential that only the

supplied power cord be used. Use only shielded cables to connect I/O devices to this equipment. You

are cautioned that changes or modifications not expressly approved by the party responsible for

compliance could void your authority to operate the equipment.

(Reprinted from the Code of Federal Regulations #47, part 15.193, 1993. Washington DC: Office

of the Federal Register, National Archives and Records Administration, U.S. Government

Printing Office.)

IC Statement

Operation is subject to the following two conditions:

• This device may not cause interference and

• This device must accept any interference, including interference that may cause undesired

operation of the device.

To prevent radio interference to the licensed service (i.e. co-channel Mobile Satellite systems)

this device is intended to be operated indoors and away from windows to provide maximum

shielding. Equipment (or its transmit antenna) that is installed outdoors is subject to licensing.

Because high power radars are allocated as primary users (meaning they have priority) in

5250-5350 MHz, these radars could cause interference and/or damage to license exempt LAN

devices.