User's Manual

authenticator by the authentication protocol operating over the TLS tunnel.
This identity is securely transmitted to the server only after an encrypted
channel has been established.
■ Domain: Name of the domain on the authentication server. The server name
identifies a domain or one of its sub-domains (for example, zeelans.com,
where the server is blueberry.zeelans.com). NOTE: Contact your administrator
to obtain the domain name.
■ Password: Specifies the user password. The password characters appear as
asterisks. This password must match the password that is set in the
authentication server.
■ Confirm Password: Reenter the user password.
2. Click OK to save the credentials.
3. Click Connect to connect to the selected wireless network.
If you did not select Use Windows logon on the Security Settings page and also
did not configure user credentials, an Enter Credentials message appears when
you attempt to connect to this profile. Enter your user name and password. Click
Save User Credentials to save the credentials for future use with this 802.1x
profile.
4. Click OK to close Intel PROSet/Wireless.
Set up a Client with WEP Data Encryption and EAP-SIM NetworK
Authentication
EAP-SIM uses a dynamic session-based WEP key, which is derived from the client adapter and
RADIUS server, to encrypt data. EAP-SIM requires you to enter a user verification code, or
Personal Identification Number (PIN), for communication with the Subscriber Identity Module
(SIM) card. A SIM card is a special smart card that is used by Global System for Mobile
Communications (GSM) based digital cellular networks. To add a profile with EAP-SIM
authentication:
1. On the Profile page, click Add to open General Settings.
2. Profile Name: Enter a profile name.
3. Wireless Network Name (SSID): Enter the network identifier.
4. Operating Mode: Click Network (Infrastructure).
5. Click Next to access the Security Settings.
6. Click Enterprise Security.
7. Network Authentication: Select Open (Recommended).
8. Data Encryption: Select WEP.
9. Click Enable 802.1x.
10. Authentication type: Select EAP-SIM.
EAP-SIM authentication can be used with:
● Network Authentication types: Open, Shared, WPA - Enterprise and WPA2 - Enterprise
● Data Encryption types: None, WEP, AES-CCMP and CKIP
EAP-SIM User (optional)