User's Manual

Appendix A

CE Mark Warning

This is a Class B product, in a domestic environment, this product may cause radio interference,

in which case the user may be required to take adequate measures.

FCC Radio Frequency Interference Requirements

This device is restricted to INDOOR USE due to its operation in the 5.15 to 5.25GHz frequency

range. FCC requires this product to be used indoors for the frequency range 5.15 to 5.25GHz to

reduce the potential for harmful interference to co-channel of the Mobile Satellite Systems. High

power radars are allocated as primary user of the 5.25 to 5.35GHz and 5.65 to 5.85GHz bands.

These radar stations can cause interference with and / or damage this device.

IMPORTANT: This device and its antenna(s) must not be co-located or operating in conjunction with

any other antenna or transmitter.

FCC Radio Frequency (RF) Exposure Caution Statement

FCC Caution: Any changes or modifications not expressly approved by the party responsible for

compliance could void the user’s authority to operate this equipment. “ASUS declare that this device

in the 2.4GHz is limited to Channels 1 through 11 by specified firmware controlled in the USA.”

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. To maintain compliance with FCC RF exposure compliance requirements, please

avoid direct contact to the transmitting antenna during transmitting. End users must follow the

specific operating instructions for satisfying RF exposure compliance. For operation within

5.15GHz and 5.25GHz frequency ranges, it is restricted to indoor environment, and the antenna

of this device must be integral.

IC Radiation Exposure Statement

This equipment complies with IC radiation exposure limits set forth for an uncontrolled

environment. To maintain compliance with IC RF exposure compliance requirements, please

avoid direct contact to the transmitting antenna during transmitting. End users must follow the

specific operating instructions for satisfying RF exposure compliance.

Declaration of Conformity (R&TTE directive 1999/5/EC)

The following items were completed and are considered relevant and sufficient:

• Essential requirements as in [Article 3]

• Protection requirements for health and safety as in [Article 3.1a]

• Testing for electric safety according to [EN 60950]

• Protection requirements for electromagnetic compatibility in [Article 3.1b]

• Testing for electromagnetic compatibility in [EN 301 489-1] & [EN 301]

• Testing according to [489-17]

• Effective use of the radio spectrum as in [Article 3.2]

• Radio test suites according to [EN 300 328-2]