User's Manual Part 2
94
Replaceable batteries
If an equipment is provided with a replaceable battery and if replacement by an incorrect type could result in an
explosion (e.g. with some lithium batteries), the following applies:
– if the battery is placed in an OPERATOR ACCESS AREA, there shall be a marking close to the battery or a
statementinboththeoperatingandtheservicinginstructions;
– if the battery is placed elsewhere in the equipmen, there shall be a marking close to the battery or a statement in the
servicing instructions.
The marking or statement shall include the following or similar text:
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED
BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING
THE INSTRUCTIONS
Compliance is checked by inspection.
CAUTIN:TomaintaincompliancewithFCC’sRFexposureguidelines,thisequipmentshouldbeinstalledand
operatedwithminimumdistance20cmbetweentheradiatorandyourbody.Useonthesuppliedantenna.Unauthorized
antenna,modication,orattachmentscoulddamagethetransmitterandmayviolateFCCregulations.
MPE Statement (Safety Information)
Your device contains a low power transmitter. When device is transmitted it sends out Radio Frequency (RF) signal.
Safety Information
In order to maintain compliance with the FCC RF exposure guidelines, this equipment should be installed and operated
withminimumdistance20cmbetweentheradiatorandyourbody.Useonlywithsuppliedantenna.Unauthorized
antenna,modication,orattachmentscoulddamagethetransmitterandmayviolateFCCregulations.
Caution Statement of the FCC Radio Frequency Exposure
This Wireless LAN radio device has been evaluated under FCC Bulletin OET 65C and found compliant to the
requirements as set forth in CFR 47 Sections 2.1091, 2.1093, and 15.247(b)(4) addressing RF Exposure from radio
frequency devices. The radiation output power of this Wireless LAN device is far below the FCC radio frequency
exposure limits. Nevertheless, this device shall be used in such a manner that the potential for human contact during
normaloperation—asamobileorportabledevicebutuseinabody-wornwayisstrictlyprohibit.Whenusingthis
device, a certain separation distance between antenna and nearby persons has to be kept to ensure RF exposure
compliance. In order to comply with the RF exposure limits established in the ANSI C95.1 standards, the distance
between the antennas and the user should not be less than 20cm.