User's Manual

TITLE:
Product Specification for HS-W1
Revision:
001
Date:
11/30/2011
Prepared by:
Approved by:
Page: 6 of 18
本文件為美律實業股份有限公司專有之財產，非經書面許可，不准透露或使用本資料，亦不准複印，複製或轉變成任何其他形式使用。
The information contained herein is the property of Merry and shall not be distributed reproduced, or disclosed in whole or in part without prior written
permission of Merry.
Red LED turns off when battery finishes charging.
Red LED flash slowly when handset is on low-battery mode.
Red LED flash quickly when handset is error charging(Charge Suspend for temperature,
Timer Fault, Input power overvoltage, Battery short).
LEFT SIDE
Boom Switch: Rotate boom down to enable the MIC and pick up skype-in
RED LED: RED LED turns on when MIC enabled.
.
3.4 ASSEMBLY REQUIREMENTS
3.4.1 Electrical Specifications
3.4.2 Battery Specifications (For Reference Only)
Battery Type
Lithium Ion Polymer
Battery Capacity
410 mAh
Battery Voltage
3.7V (Nominal)
Operating Voltage
3.3 ~ 4.2V
Maximum Fast Charge Rate
200 mA
Battery Life Cycle
≥300 Cycles
3.4.3 Input requirements
Input DC Voltage
5V 5%
Input Current
100mA (min.), 250mA (max) Note the max current is the maximum
current allowed by the device during loss of charge control. This
loss of charge control constitutes a single fault condition of the
device. The device shall limit the current by some means to this
max limit.
Input connector
Type-B Micro USB
Charging time
3hr