User's Manual

TITLE:
Product Specification for HS-W1
Revision:
001
Date:
11/30/2011
Prepared by:
Approved by:
Page: 5 of 18
本文件為美律實業股份有限公司專有之財產，非經書面許可，不准透露或使用本資料，亦不准複印，複製或轉變成任何其他形式使用。
The information contained herein is the property of Merry and shall not be distributed reproduced, or disclosed in whole or in part without prior written
permission of Merry.
3 ELECTRICAL SECTION
3.1 Physical Characteristics
1. Indicator Lights: Provides a visual cue regarding the status of the headset
2. Power ON/OFF switch: Push button to turns headset on and off
3. Volume Control Buttons: Adjusts the speaker (receiver) volume
4. Micro-USB power connector: Allows connection to PC USB only for charging.
5. Boom Switch: Swim down to enable MIC.
3.2 Hardware Description
The Headphones contains a 2.4G module, battery, and acoustic transducers for audio
communication via the RF link to a PC or NB. A LED provides visual feedback to the users
and others about the status of the headphones. There are two user interface regions, left and
right sides, to operate all control features of the headphones, rotating boom switch, volume up
and down.
3.3 Functionality
RIGHT SIDE
Volume Control: Increase and decrease volume buttons. (volume mute a bit,pop up noise,
reset way)
Power On/Off&Pairing mode&HW reset : multi-function button
Press 2 sec Power On/Off
Press 5 sec enter pairing mode
Press 10 sec HW Reset
LED: Indicate the status of headset.
Power LED: Dual Color LED, RED and GREEN.
Green LED flash slowly in no-pairing mode.
Green LED turns on constant and turns off after 3min. when handset pairs success.
Green LED flash quickly when handset is pairing.
Red LED turns on constant when handset is charging.