User's Manual

TITLE:
Product Specification for HS-W1
Revision:
001
Date:
11/30/2011
Prepared by:
Approved by:
Page: 16 of 18
本文件為美律實業股份有限公司專有之財產，非經書面許可，不准透露或使用本資料，亦不准複印，複製或轉變成任何其他形式使用。
The information contained herein is the property of Merry and shall not be distributed reproduced, or disclosed in whole or in part without prior written
permission of Merry.
C-4
Altitude test (Operation)
Operation = 15000 feet , -14.7℃ , 8hrs
C-5
Thermal Profile Measurement
25℃,35℃,40 ℃ , 2hrs (each condition)
C-6
Non-OP High
Temperature/Humidity Test
Ta=60℃ , 90% RH , 72 hrs
C-7
Non-OP Low Temperature Test
Ta= - 40℃ , 72 hours
C-8
Audio Signal Measurement
According to vender spec
D. Durability Test for Dongle
D-1
Pressure Test
Location:Top & Bottom
Disc Radius:10cm
Pressure Force:50kg
Pressure Hold Time:60 sec
Number of press: One time
D-2
I/O Connector Insert/Remove Test
Test Frequency: 20 times/min
Test Cycle:4000 times
D-3
Bending Test
Plug into the USB receptacle (face side and back side):
Diameter 12mm cylinder, Pressure / Stroke(vertical on
dongle): 5kg / 5mm, 10 cycles
D-4
Bending Life Test
Plug into the USB receptacle (face side and back side):
Cylinder diameter 12mm, Pressure / Stroke(vertical on
dongle): 2.5kg / 10mm, 1500 cycles, check function
every 100 cycles
E. Printing Test
E-1
Rubber test
Load: 500g, times: 65 cycles ;
Abrasion Resistance: EF74
E-2
Alcohol test
Load: 500g, times: 30 ;Alcohol (95%)
E-3
Adhesion test
10 X10 squares ; (pass rating: 5B)
E-4
Cosmetics test
70degC, 90%RH, 24hrs (NIVEA and Atrix cream)
F. Additional Test
F-1
Human perspiration test (SEMC)
48 hours at temperature of 45°C and 50-60 % RH
G. Package Shipment Test
F-1
Cold Storage Test
Temperature:-40℃
Duration:72 hours
F-2
Damp Heat Storage Test
Temperature:60℃/90%
Duration:72 hours
F-3
Packaging Vibration Test
5~200 hz, 60 min, 1.48Grms, 3 axes
Reference ASTM LevelⅡ Truck Spectrum