User's Manual
Table Of Contents
- WebSTAR DPR2320 and EPR2320 Gateway Cable Modems User's Guide, Software Release v2.0.1 r1132
- WebSTAR DPR2320 and EPR2320 Gateway Cable Modems User's Guide
- WebSTAR™ DPR2320™ and EPR2320™ Gateway Cable Modems User’s Guide Introduction
- In This Guide
- IMPORTANT RULES FOR SAFE OPERATION
- What’s In the Carton?
- Front Panel Description
- Back Panel Description
- Where is the Best Location for My Gateway Cable Modem?
- What are the System Requirements for Internet Service?
- How Do I Set Up My High-Speed Internet Access Account?
- How Do I Connect My Devices to Use the Internet?
- How Do I Configure TCP/IP Protocol?
- How Do I Install USB Drivers?
- How Do I Troubleshoot My Internet Service Installation?
- What are the Requirements for Ethernet Network Devices?
- How Do I Select and Place Ethernet Network Devices?
- How Do I Connect Ethernet Network Devices?
- What are the Requirements for USB Network Devices?
- How Do I Select and Place USB Network Devices?
- How Do I Connect USB Network Devices?
- What are the Requirements for Wireless Network Devices?
- How Do I Select and Place Wireless Network Devices?
- How Do I Install Wireless Network Devices?
- How Do I Configure the Gateway Cable Modems?
- Having Difficulty?
- Tips for Improved Performance
- How Do I Renew the IP Address on My PC?
- Front Panel Status Indicator Functions
- Notices
- FCC Compliance
- For Information
WebSTAR DPR2320 and EPR2320 Gateway Cable Modems User’s Guide
52
Setup Advanced Settings – Port Triggers Page Description
Use this page to enter and enable the port forwarding trigger and target range
start and end ports along with protocol information in the appropriate fields. The
following example illustrates how to use the port triggering feature to configure
the Microsoft X-Box Online Live for Internet gaming.
For most widely used applications (including Microsoft X-Box Online Live),
the WebSTAR firewall automatically maps and opens ports required for that
application while the application is in use.
1.
In the first row, enter 88 in both Start Port and End Port fields.
2.
In the same row, select UDP from the drop-down list in the Protocol
field, and then select the box in the Enable field.
3.
In the second row, enter 3074 in both Start Port and End Port fields.
4.
In the same row as the second entry, select Both, and then select the
box in the Enable field.
5.
Click Apply to apply and save your new port forwarding settings.