User's Manual
Table Of Contents
- WebSTAR DPR2320 and EPR2320 Gateway Cable Modems User's Guide, Software Release v2.0.1 r1132
- WebSTAR DPR2320 and EPR2320 Gateway Cable Modems User's Guide
- WebSTAR™ DPR2320™ and EPR2320™ Gateway Cable Modems User’s Guide Introduction
- In This Guide
- IMPORTANT RULES FOR SAFE OPERATION
- What’s In the Carton?
- Front Panel Description
- Back Panel Description
- Where is the Best Location for My Gateway Cable Modem?
- What are the System Requirements for Internet Service?
- How Do I Set Up My High-Speed Internet Access Account?
- How Do I Connect My Devices to Use the Internet?
- How Do I Configure TCP/IP Protocol?
- How Do I Install USB Drivers?
- How Do I Troubleshoot My Internet Service Installation?
- What are the Requirements for Ethernet Network Devices?
- How Do I Select and Place Ethernet Network Devices?
- How Do I Connect Ethernet Network Devices?
- What are the Requirements for USB Network Devices?
- How Do I Select and Place USB Network Devices?
- How Do I Connect USB Network Devices?
- What are the Requirements for Wireless Network Devices?
- How Do I Select and Place Wireless Network Devices?
- How Do I Install Wireless Network Devices?
- How Do I Configure the Gateway Cable Modems?
- Having Difficulty?
- Tips for Improved Performance
- How Do I Renew the IP Address on My PC?
- Front Panel Status Indicator Functions
- Notices
- FCC Compliance
- For Information
How Do I Configure the Gateway Cable Modems?
47
Configuring MAC Address Filters
Use the Setup Advanced Settings – MAC Filtering page to configure MAC
address filters. These filters prevent individual MAC addresses from accessing
the Internet. You can also prevent individual PCs from sending outgoing
TCP/UDP traffic to the WAN using their MAC address.
If you are not familiar with the advanced settings detailed in this section,
contact your cable service provider before you attempt to change any of the
gateway cable modem default advanced MAC filtering settings.
Click MAC Address Filtering in the Advanced Settings section of the Setup
page to access the Setup Advanced Settings – MAC Filtering page.
Setup Advanced Settings – MAC Filtering Page Example
The following illustration is an example of the Setup Advanced Settings – MAC
Filtering page.
Setup Advanced Settings – MAC Filtering Page Description
Use this page to enter the MAC address or MAC addresses of devices that
cannot have access to the Internet. Click Apply to apply and save your new
MAC address filter settings.