User's Manual
Table Of Contents
- WebSTAR DPR2320 and EPR2320 Gateway Cable Modems User's Guide, Software Release v2.0.1 r1132
- WebSTAR DPR2320 and EPR2320 Gateway Cable Modems User's Guide
- WebSTAR™ DPR2320™ and EPR2320™ Gateway Cable Modems User’s Guide Introduction
- In This Guide
- IMPORTANT RULES FOR SAFE OPERATION
- What’s In the Carton?
- Front Panel Description
- Back Panel Description
- Where is the Best Location for My Gateway Cable Modem?
- What are the System Requirements for Internet Service?
- How Do I Set Up My High-Speed Internet Access Account?
- How Do I Connect My Devices to Use the Internet?
- How Do I Configure TCP/IP Protocol?
- How Do I Install USB Drivers?
- How Do I Troubleshoot My Internet Service Installation?
- What are the Requirements for Ethernet Network Devices?
- How Do I Select and Place Ethernet Network Devices?
- How Do I Connect Ethernet Network Devices?
- What are the Requirements for USB Network Devices?
- How Do I Select and Place USB Network Devices?
- How Do I Connect USB Network Devices?
- What are the Requirements for Wireless Network Devices?
- How Do I Select and Place Wireless Network Devices?
- How Do I Install Wireless Network Devices?
- How Do I Configure the Gateway Cable Modems?
- Having Difficulty?
- Tips for Improved Performance
- How Do I Renew the IP Address on My PC?
- Front Panel Status Indicator Functions
- Notices
- FCC Compliance
- For Information
How Do I Configure the Gateway Cable Modems?
45
Setup Advanced Settings – Options Page Description
The following table provides a description of the fields within the Setup Advanced
Settings – Options page.
If you make changes in the Setup Advanced Settings – Options page, click
Apply to apply and save your new IP address filter settings.
Field Name Description
WAN Blocking Checking this box prevents the gateway cable
modem from being visible to the WAN. For
example, pings to the WAN IP address are not
returned
Ipsec PassThrough Checking this box allows applications that use
IPSec (IP Security) to pass through the firewall
PPTP PassThrough Checking this box allows applications that use Point
to Point Tunneling Protocol (PPTP) to pass through
the firewall
Remote Config
Management
Checking this box allows Remote Configuration
Management from the WAN side of the gateway
cable modem. Access is allowed by using the
password to access the WebWizard.
If you enable (check) Remote Configuration
Management, when you are away from your home
or office, you can access the settings of your
gateway by entering the WAN IP address into any
PC browser. If you choose to enable (check) this
feature, be sure to set up a user password to
prevent unauthorized access to your gateway
settings.
Multicast Enable Checking this box allows multicasts to pass from
the WAN side through to the private network