User's Manual

34 4011350 Rev A
How Do I Connect USB Network Devices?
Note: Verify that you have installed the USB drivers on your PC before continuing
with these instructions. See How Do I Install USB Drivers? (on page
25), for more
information on installing the USB drivers.
1 Select locations for USB network devices. For more information, see How Do I
Select and Place USB Network Devices? (on page 31).
2 Connect the USB port on the wireless home gateway to your PC.
3 Connect one or more USB network device to the wireless home gateway.
4 Connect the active RF coaxial cable to the CABLE connector on the back of the
wireless home gateway. Use an optional cable signal splitter to add a TV, a
DHCT or set-top converter, or a VCR.
5 After all connections are complete, insert the AC power cord into the POWER
connector on the back of the wireless home gateway, and then plug the cord into
an AC power source.
6 The wireless home gateway begins an automatic search to locate and sign on to
the network. In some unusual circumstances, this process may take up to 5
minutes. The wireless home gateway is ready for use when the ONLINE LED
status indicator on the front panel stops blinking and illuminates continuously.
7 Verify that all USB network devices are working properly.
Note: You will not be able to check the front panel LED status indicator on the
wireless home gateway until after one or more Ethernet network devices are
connected to the wireless home gateway.