User's Manual

4011350 Rev A 131
Front Panel LED Status Indicator Functions
Normal Operations (AC Power applied)
The following chart illustrates the appearance of the wireless home gateway front
panel LED status indicators during normal operations when AC power is applied to
the gateway.
Step 8
Front Panel LED Status Indicators During Normal Operations
Front Panel
Indicator
Normal Operations
1 POWER ON
2 DS BLINKS - To indicate data is being transferred between the modem
and the network
3 US BLINKS - To indicate data is being transferred between the modem
and the network
4 ONLINE ON
5 LAN 1
through LAN
4/USB
ON - When a single device is connected to either the Ethernet or USB
port and no data is being sent to or from the modem
BLINKS - When only one Ethernet or USB device is connected and
data is being transferred between the consumer premise equipment
(CPE) and the wireless home gateway
OFF - When no devices are connected to either the Ethernet or USB
ports
NOTE: With both Ethernet and USB devices connected to the modem
at the same time, when data is being transferred through only one of
the devices (Ethernet or USB), the indicator will illuminate
continuously. Whenever data is being sent through both data ports
(Ethernet and USB) simultaneously, the indicator will blink as
described above.
6 WIRELESS
 ON when the wireless access point is enabled and operational
 BLINKS when data is being transferred between the CPE and the
wireless home gateway
 OFF when the wireless access point is disabled by the user
7 TEL1
 ON when telephony service is enabled
 BLINKS when line 1 is in use
8 TEL2
 ON when telephony service is enabled
 BLINKS when line 2 is in use
9 BATTERY
 ON when battery is charged
 BLINKS when battery charge is low
 OFF when there is no battery in the unit