User’s Manual ASUS BT-180 1
Contents Notice ........................................................................................…...…. 3 Safety statements .............................................................................…. 4 System requirements................................................….................…........ 6 Installing the device drivers........................................….............………....… 6 BT-183 specification summary....……................................. ...…........…....….
Notices Federal Communications Commission Statement This device complies with FCC Rules Part 15. Operation is subject to the following • This device may not cause harmful interference, and • This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the Federal Communications Commission (FCC) rules.
Safety statements Regulatory Information/Disclaimers Installation and use of this Bluetooth device must be in strict accordance with the instructions included in the user documentation provided with the product. Any changes or modifications (including the antennas) made to this device that are not expressly approved by the manufacturer may void the user’s authority to operate the equipment.
a body-worn way is strictly prohibit. When using this device, a certain separation distance between antenna and nearby persons has to be kept to ensure RF exposure compliance. In order to comply with the RF exposure limits established in the ANSI C95.1 standards, the distance between the antennas and the user should not be less than [20cm]. RF Exposure The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
System requirements Before installing the ASUS Bluetooth module, make sure that your system meets the following requirements: • Intel® Pentium® 4 or AMD K7/K8 system • Minimum 64MB system memory • Windows® 98SE/ME/2000/XP operating system • Optical drive (for software installation) • An available USB port (USB 2.0 recommended because USB 1.
BT-180 specification summary i. Fully qualified Bluetooth v2.0 system ii. Enhanced Data Rate (EDR) compliant for both 2Mbps and 3Mbps supported iii. Fully speed operation with Piconet and Scatternet support iv. Electrical compliant to USB1.1&2.0 through proprietary Pin Connector (Note: Vcc is 3.3V, 5V is not allowed) v. Implement 802.11 coexistence solution by AFH (Adjacent Frequency Hopping), WCS (Wireless Coexistence System), and Bluetooth Priority vi. Slim module with 35*11 mm dimension vii.
