User's Manual

Get started! 1-9
Installing and removing the battery
NOTE At this point, the bottom edge of the battery should fit the
bottom edge of the compartment.
3. Push the battery upward until you
hear the battery latch click
indicating that the battery is locked
in place, and the battery contacts
matched the 4-pin connector on the
compartment.
NOTE You need to remove the back cover to access the battery
compartment. Refer to the section “Removing and replacing
the back cover” on page 1-7 for instructions.
To install the battery:
1. Position and insert the left side of the
battery with the notches matching the
tabs on the left side of the compartment.
2. Press the right side of the battery to
completely fit it into the compartment.
Notches on
the battery
Battery latch locked
Battery contacts