Disassembly Procedure 2 Chapter Disassembly Procedure Please follow the information provided in this section to perform the complete disassembly procedure of the notebook. Be sure to use proper tools described before. A SUS Z9200K Series Notebook consists of various modules. This chapter describes the procedures for the complete notebook disassembly. In addition, in between procedures, the detailed disassembly procedure of individual modules will be provided for your service needs.
Disassembly Procedure B A T T E R Y Battery Module The illustration below shows how to remove the battery module. 1. Unlock and hold the latches, and remove the battery. L 2. Slide the battery latch (No.1) to unlock and Firmly slide the other latch (No.2) to the top and remove the battery S E C O N D M E M O R Y M O D U L E M E M O R Y R E M O V A L Memory Module The Z9200K Series Notebook do not have onboard RAM. There are two SO-DIMM sockets for installing SO-DIMM RAM.
Disassembly Procedure 2. Take the memory DIMM cover away as the picture shows. W I R E L E S S L A N M O D U L E R E M O V A L W I R E L E S S Wireless Lan Module The illustration below show show how to remove the Wireless LAN module Disassembling Wireless Lan board. 1. Remove 2 Antenna cables from Wireless LAN Module. L A N R E M O V A L 2. Take the Wireless Lan away as the picture shows.
Disassembly Procedure H D D M O D U L E H D D HDD Module The illustrations below show how to remove the HDD module from the notebook. Removing HDD Module 1. Remove 1 screw and lift the HDD cover away. M O D U L E R E M O V A L 2. Pull the hard disk module toward the direction of the arrow and lift it up and take it out.
Disassembly Procedure O P T I C A L D R I V E ODD Module 1. Remove 2 screws. R E M O V A L 2. Remove the Mylar. 3. Push the metal plate with a screw driver and pull the ODD out.
Disassembly Procedure C P U M O D U L E R E M O V A L C P U R E M O V A L CPU Module The illustrations below show how to remove the CPU module from the notebook. Removing CPU 1. Remove the rubber. 2. Remove 4 screws aside the CPU. And take away the thermal module. 2 1 3 4 3. Remove the CPU slot and take away the CPU.
Disassembly Procedure L C D M O D U L E L C D D I S A S S E M B L Y LCD Module The illustrations below show how to disassemble the LCD module. The module contains LCD panel, Inverter board, LCD Hinge bracket, Hinge cover, LCD front cover, LCD back cover Disassembling LCD Module 1. Remove 3 screws on both side. 2. Remove both hinge covers 3.
Disassembly Procedure 4. Remove 1 screw and disconnect the connector. 5. Remove 1 screw and disconnect the connector. 6. Remove 2 screws on both ends.
Disassembly Procedure 7. Remove the LCD module from system. L C D D I S A S S E M B L Y Disassembling LCD Module 1. Remove 5 rubber pads and 5 screws(M2.5 x 8L) from LCD module. 2. Prying the inside edges of the bezel, then separate it from LCD back cover and take LCD front bezel away.
Disassembly Procedure Disassembling inverter board 3. Remove 1tape and disconnect 2 cables. 4. Take away the inverter board. Disassembling LCD panel 1. Remove 10 screws and take away the LCD panel.
Disassembly Procedure 2. Finally, Remove 4 screws on the right LCD bracket , and 4 screws on the left side to disassemble LCD brackets. 3. Remove one tape and disconnect the cable.
Disassembly Procedure Disassembling speaker 1. Tear of the tape and disconnect the cable from Video Camera module. 2. Disconnect the cable. 3. Remove all tapes. 4. Remove 4 screws and take away the both cable.
Disassembly Procedure 5. Take away the both cable. K E Y B O A R D D I S A S S E M B L Y Keyboard Module The illustration of below shows how to remove the keyboard Removing Keyboard Cover 1. Remove 2 screws and Unlock 3 keyboard latches. K / B C O V E R R E M O V A L 2.
Disassembly Procedure Main Board Module The illustrations below show how to disassemble and remove the Main Board module of the notebook. Removing Top Case 1. Disconnect the Touchpad cable. 2. Turn over the NB and remove all screws on bottom case. 3. Remove 2 screws here.
Disassembly Procedure 4. Remove 1 screw on Top case. 5. Separate the Top Case and Bottom case. Removing Touchpad bracket 1. Disconnect the Touchpad cable.
Disassembly Procedure 2. Remove All screws and take away the bracket 3. Take away the Touchpad. Disassembling Speaker Module 1. Disconnect the speaker cable.
Disassembly Procedure 2. Remove right side and left side 2 screws then take away the both speaker. Removing Main Board 1. Remove 4 screws on the M/B and remove the M/B from the bottom case. Removing Modem board 1. Remove 2 screws and disconnect the cable.
Disassembly Procedure 2. Take away the modem board. 3. Disconnect the cable. H E A T S I N K M O D U L E R E M O V A L H E A T Heat Sink Module The illustrations below show how to remove the CPU module from the notebook. Removing Heat sink S I N K R E M O V A L 4. Disconnect the cable and remove 4 screws on CPU fan and take away the Fan.
