User Manual

2-30
Chapter 2: Hardware Information
4. RAID selection jumper setting (3-pin RAID_SEL1)
ThisjumperallowsyoutoselectthePCHSATARAIDmodetouseLSIMegaRAID
software or Intel
®
RapidStorageTechnologyenterprise3.0RAID.Placethejumper
capsoverpins1–2ifyouwanttousetheLSIMegaRAIDsoftwareRAIDUtility
(default);otherwise,placethejumpercapstopins2–3tousetheIntel
®
RapidStorage
TechnologyEnterpriseOptionROMUtility.
5. ME firmware force recovery setting (3-pin ME_RCVR1)
ThisjumperallowsyoutoforceIntelManagementEngine(ME)bootfromrecovery
modewhenMEbecomecorrupted.