User Manual

3-40
Chapter 3: BIOS Setup
Chapter 3
The following items appear only when BMC Support is set to [Enabled].
Wait for BMC [Disabled]
AllowsyoutoenableordisablewaitforBMCresponseforspeciedtimeout.
Congurationoptions:[Disabled][Enabled]
FRB-2 Timer [Enabled]
Allows you to enable or disable FRB-2 timer (POST timer).
Congurationoptions:[Disabled][Enabled]
FRB-2 Timer timeout [6 minutes]
Allows you to select the FRB-2 Timer Expiration value.
Congurationoptions:[3minutes][4minutes][5minutes][6minutes]
FRB-2 Timer Policy [Do Nothing]
Allows you to select the how the system should respond in FRB-2 Timer expires.
Congurationoptions:[DoNothing][Reset][PowerDown][PowerCycle]
OS Watchdog Timer [Disabled]
This item allows you to start a BIOS timer which can only be shut off by Management
Software after the OS loads.
Congurationoptions:[Disabled][Enabled]
ThefollowingitemsarecongurableonlywhenOS Watchdog Timer is set to [Enabled].
OS Wtd Timer Timeout [10 minutes]
AllowsyoutocongurethelengthfortheOSBootWatchdogTimer.
Congurationoptions:[5minutes][10minutes][15minutes][20minutes]
OS Wtd Timer Policy [Reset]
Thisitemallowsyoutocongurethehowthesystemshouldrespondifthe
OSBootWatchTimerexpires.
Congurationoptions:[DoNothing][Reset][PowerDown][PowerCycle]
Serial Mux [Disabled]
AllowsyoutoenableordisableSerialMuxconguration.
Congurationoptions:[Disabled][Enabled]
BMC Warm Reset
This item allow you to perform a BMC warm reset.