User Manual

2-12
Chapter 2: Basic Installation
Chapter 2
• Donotunplugportabledisk,powersystem,orshorttheCLRTCjumperwhileBIOS
updateisongoing,otherwiseupdatewillbeinterrupted.Incaseofinterruption,please
pressandholdtheBIOS_FLBKbuttonfor3secondsagaintorestarttheprocess.
• Ifthelightashesforvesecondsandturnsintoasolidlight,thismeansthatthe
BIOSFlashbackisnotoperatingproperly.Pleasecheckthefollowingwhenthis
happens:
 - TheUSBdriveshouldonlycontainasinglepartition.
 - TheUSBdriveshouldbeformattedtoaFAT32,FAT16,orNTFSlesystem.
 - TheBIOSlenameshouldbecorrectlynamed,andintherootfolderoftheUSB
drive.
 - Iftheproblempersists,theUSBdrivemaynotbecompatible,pleasetryanother
USBdriveofadifferentbrand/model.
 ThenretrytheashbackbypressingtheBIOSashbackbuttonforthreesecondsuntil
theFlashbackLEDstartstoblink
.
• Refertosection1.1.8 Onboard LEDsformoreinformationoftheFlashbackLED.
• FormoreBIOSupdateutilitiesinBIOSsetup,refertothesection3.10 Updating BIOS
inChapter3.