English 1588 ® Wireless Local Area Network Card WL-107 (For 802.
Quick Start Guide English System Requirements To begin using the ASUS WLAN Card, you must have the following minimum requirements: • • • • Windows XP/2000/ME/98SE or Linux Redhat (Version 7.1 or later) Standard PCMCIA Slot Type II 32MB system memory or larger 300MHz processor or higher Installation Procedures Linux users: This manual is meant for Windows users. Information pertaining to Linux is located in “readme.txt” in the Linux folder. Linux drivers are also located in the same folder.
Quick Start Guide English Installing the ASUS WLAN utilities and driver (Cont.) 3. Click Next after reading the Information. 4. Click Next to use the default Destination Folder or click Browse to select another folder. 5. Click Next to place icons in the default program folder or type another folder name. 6. When Setup is complete, click Finish to exit the installation wizard and restart Windows. 7.
Quick Start Guide Configuring the ASUS WLAN utility English After installing the ASUS WLAN Card Utilities, you will need to make some settings before being able to use your wireless connection. Double-click the ASUS WLAN Control Center icon to start the utility. 4 1. Right-click the ASUS WLAN icon and select “Wireless Settings” 2. Set the Network Name (SSID) to the same name as the SSID set in your wireless access point. 3. Use “Site Survey” if you don’t know the name of your access point(s). 4.
Quick Start Guide English Configuring the ASUS WLAN utility (Cont.) 5. Check the “Status” page to see the “Association State”. It should show “Connected xx:xx:xx:xx:xx:xx”. 6. You can also see the connection quality on the “Connection” page. Click OK to exit the utility. Soft AP (Windows XP Only) Soft AP mode allows the ASUS WLAN card to act as a virtual access point. The computer needs to be connected to a wired network using an Ethernet connection in order to provide network access to WLAN clients.
Quick Start Guide Soft AP (Windows XP Only) (Cont.) English 3. Enable ICS* and Firewall if desired. Refer to Windows help for information on “Internet Connection Sharing”. 4. You can easily switch between Soft AP and Station mode by right clicking the taskbar icon and selecting “A-S Change Mode”. *ICS is used to share this computer’s Internet connection with the rest of the computers on your network.
