Specifications

2-16 Chapter 2: Basic installation

2.7.2 Floppy disk drive

The system supports a 3.5” oppy disk drive.

To install a oppy disk drive:

1. Place the chassis upright, then remove the lower 3.5” drive bay metal

plate cover.

2. Insert the oppy disk drive to the bay, then carefully push the drive

until its screw holes align with the holes on the bay.

3. Secure the oppy disk drive with two screws on both sides of the bay.

4. Connect the signal (A) and power (B) plugs to connectors at the back

of the drive.

5. Connect the other end of the oppy cable to the oppy disk drive

connector (labeled FLOPPY) on the motherboard. See page 4-6 for the

connector location.