User Guide
2-19ASUS TW100-E5
7. Secure the card to the chassis with
the bracket screw you removed
earlier.
2.7.2 Conguringanexpansioncard
After installing the expansion card, congure it by adjusting the software settings.
1. Turn on the system and change the necessary BIOS settings, if any. See
Chapter 4 for information on BIOS setup.
2. Assign an IRQ to the card. Refer to the tables on the next page.
3. Install the software drivers for the expansion card.
• When using PCI cards on shared slots, ensure that the drivers support
“Share IRQ” or that the cards do not need IRQ assignments. Otherwise,
conicts will arise between the two PCI groups, making the system
unstable and the card inoperable. Refer to the table on the next page for
details.
• By default, if you install a discrete graphics card on the PCIe x16 slot, the
onboard GPU will be automatically disabled. Connect the VGA cable to
the discrete graphics card rst when using a discrete graphics card. To
use quad-display, enable both the onboard GPU and the discrete Quadro
graphics card. See section 4.4.2Chipset>SouthbridgeConguration
for details.