User’s Manual

1-2
Chapter 1: Product Introduction
1.2.1 Layout contents
Connectors/Jumpers/Slots Page
1. ATX power connectors (24-pin EATXPWR, 8-pin EATX12V)
1-2
2. CPU, chassis, and AIO pump fan connectors (4-pin CPU_FAN, 4-pin CHA_FAN1~2,
4-pin AIO_PUMP FAN)
1-3
3. Intel
®
LGA1151 CPU socket 1-3
4. DDR4 DIMM slots 1-3
5. AURA RGB header (4-pin RGB_HEADER1~2) 1-3
6. Addressable RGB header (ADD_HEADER) 1-3
7. Q LEDs 1-4
8. USB 3.1 Gen 1 connector (20-1 pin U31G1_56) 1-4
9. M.2 sockets (M.2_1; M.2_2) 1-4
10. Intel
®
B365 Serial ATA 6.0 Gb/s connector (7-pin SATA6G_1~6) 1-4
11. System panel connector (20-3 pin PANEL) 1-5
12. Clear RTC RAM (2-pin CLRTC) 1-5
13. USB 2.0 connector (10-1 pin USB1114) 1-6
14. TPM connector (14-1 pin TPM) 1-6
15. Serial port connector (10-1 pin COM) 1-6
16. Digital audio connector (4-1 pin SPDIF_OUT) 1-6
17. Front panel audio connector (10-1 pin AAFP) 1-6
18. PCI Express 3.0/2.0 x1 slots
1-6
19. PCI Express 3.0/2.0 x16 slots 1-6
ATX power connectors (24-pin EATXPWR, 8-pin EATX12V)
Correctly orient the ATX power supply plugs into these
connectors and push down rmly until the connectors
completely t.
EATX12V
+12V DC
+12V DC
+12V DC
+12V DC
GND
GND
GND
GND
EATXPWR
PIN 1
PIN 1
GND
+5 Volts
+5 Volts
+5 Volts
-5 Volts
GND
GND
GND
PSON#
GND
-12 Volts
+3 Volts
+3 Volts
+12 Volts
+12 Volts
+5V Standby
Power OK
GND
+5 Volts
GND
+5 Volts
GND
+3 Volts
+3 Volts
• For a fully congured system, we recommend that you use a power supply unit
(PSU) that complies with ATX 12 V Specication 2.0 (or later version) and provides
a minimum power of 350 W. This PSU type has 24-pin and 8-pin power plugs.
• We recommend that you use a PSU with higher power output when conguring a
system with more power-consuming devices or when you intend to install additional
devices. The system may become unstable or may not boot up if the power is
inadequate.