User Manual

Chapter 2: Hardware Setup
2-18
2.6 5.25-inch or 3.5-inch drives
Ensuretounplugthepowercablebeforeinstallingorremovinganysystemcomponents.
Failuretodosomaycausedamagetothemotherboardandothersystemcomponents!
Youmustremovethefrontpanelassemblybeforeinstallinga5.25-inchdrive.
2.6.1 Installing a 5.25-inch drive
3. ConnecttheSATAcabletotheSATA
connectoronthebackofthedrive.
4. Connect the 4-pin power connector from the
power supply to the power connector on the
backofthedrive.
The system comes with three 5.25-inch
drivebayslocatedontheupperfrontpart
ofthechassis.Anopticaldrivethatcomes
standardwiththesystempackageoccupies
theuppermostbay(labeled1).Thelowerbays
(labeled2and3)areavailableforadditional
5.25-inch drives or 5.25-inch to 3.5-inch hard
driveadapterforinstalling3.5-inchziporoppy
diskdrives.
1. Unscrew and remove the metal cover
ofthebaywhereyouwanttoinstallthe
5.25-inch drive.
2. Insertthedriveintothebayandslide
thebaylocktotherightuntilitclicksin
place.