User Manual

Chapter 2: Hardware Setup
2-16
6. OrientandplacetheSSDintothe
tray.
 EnsurethattheSSDisttedrmly
inside the drive tray and that the four
screws of the SSD matches the four
screws holes of the drive tray.
3. Placethedrivetrayonaatsurface.
4. Release the screws on each side of
the drive tray to release the drive tray
metalbeam.
5. Findtheharddiskdriveyouwantto
installanditsbundledscrews.
Whenthedrivetrayisout,itscaseisfacingdownwards.
2. Firmly hold the tray lever and pull the
drivetrayoutofthebay.
2.5.5 Installing a 2.5-inch hard disk drive
(TS700-E9-RS4/RS8 only)
Thesystemcomeswithtwohot-swap2.5-inchharddiskdrivesontherearpanelformounting
SATA/SASorSSDharddiskdrives.
Toinstalla2.5-inchharddiskdrive:
1. Releaseadrivetraybypushingthe
springlocktotheright,andthen
pulling the tray lever outward. The
drive tray ejects slightly after you pull
out the lever.