User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Information
- Chapter 3: Installation Options
- Chapter 4: Motherboard Information
- Chapter 5: BIOS Setup
- 5.1 Managing and updating your BIOS
- 5.2 BIOS setup program
- 5.3 Main menu
- 5.4 Ai Tweaker menu
- 5.5 Performance Tuning menu
- 5.6 Advanced menu
- 5.6.1 Trusted Computing
- 5.6.2 ACPI Settings
- 5.6.3 SMART Self Test
- 5.6.4 Super IO Configuration
- 5.6.5 Serial Port Console Redirection
- 5.6.6 Onboard LAN Configuration
- 5.6.7 APM
- 5.6.8 PCI Subsystem Settings
- 5.6.9 Network Stack Configuration
- 5.6.10 CSM Configuration
- 5.6.11 NVMe Configuration
- 5.6.12 USB Configuration
- 5.6.13 iSCSI Configuration
- 5.6.14 Intel(R) Virtual RAID on CPU
- 5.7 Platform Configuration menu
- 5.8 Socket Configuration menu
- 5.9 Event Logs menu
- 5.10 Server Mgmt menu
- 5.11 Monitor menu
- 5.12 Security menu
- 5.13 Boot menu
- 5.14 Tool menu
- 5.15 Save & Exit menu
- Chapter 6: RAID Configuration
- Chapter 7: Driver Installation
- Appendix
ASUS TS700-E9 Series
4-9
8. VGA controller setting (3-pin VGA_SW1)
This jumper allows you to enable or disable the onboard VGA controller. Set to pins
1–2 to activate the VGA feature.
• If a VGA Card is installed into a PCI Express x16 Slot, the onboard VGA function will
still be enabled.
• BMC Remote Management Function will still be available when VGA controller
settings is set to disabled, but the display will be disabled on the client device.
Ensure the ATX power supply is switched off or the power cord is detached from the power
supply when enabling or disabling the VGA controller settings using this jumper.