User Manual

Chapter 2: Hardware Setup
2-30
2.9.1 System fans
Removing the front system fan
1. Remove the two screws that secure the right
side cover. Then remove the side cover.
2.9 Removable components
You may need to remove previously installed system components when installing or removing
system devices, or when you need to replace defective components. This section tells how to
remove the following components:
1. System fans (front and rear)
2. Redundant power supply module
3. Chassis footpads
2. Locate the front system fan near the
5.25-inch drive bays.
3. Squeeze the front system fan latches
(step A) and pull out the front system fan
(step B), as shown in the right figure.
4. Follow the previous instructions in
reverse to reinstall the front system fan.
USB BIOS
Flashback
TYPE C
USB3.0
USB3.0
USB3.1
10
MIC IN
LINE OUT
LINE IN
KY
REAR
SPDIF OUT C/SUB
USB BIOS
Flashback
TYPE C
USB3.0
USB3.0
USB3.1
10
MIC IN
LINE OUT
LINE IN
KY
REAR
SPDIF OUT C/SUB
1
2
1
2
LAN port 3 LAN port 1
Q-Code Logger
Management
USB BIOS Flashback
SPDIF OUT
USB3.0
USB3.0
side
MIC IN LINE OUT LINE IN
KY
rear c/sub
1
2