Owner manual
Table Of Contents
- 1.7 LED information
- 1.6 Internal features
- 1.5 Rear panel features
- 1.4 Front panel features
- 1.3 System specifications
- 1.2 Serial number label
- 1.1 System package contents
- About this guide
- Safety information
- Notices
- Chapter 2: Hardware setup
- Chapter 3: Installation options
- Chapter 4: Motherboard Info
- Chapter 5: BIOS setup
- 5.1 Managing and updating your BIOS
- 5.2 BIOS setup program
- 5.3 Main menu
- 5.4 Advanced menu
- 5.4.1 CPU Configuration
- 5.4.2 PCH-IO Configuration
- 5.4.3 SATA Configuration
- 5.4.4 System Agent (SA) Configuration
- 5.4.5 PCI Subsystem Settings
- 5.4.6 USB Configuration
- 5.4.7 TPM
- 5.4.8 ACPI Settings
- 5.4.9 WHEA Support
- 5.4.10 NCT6779D Super IO Configuration
- 5.4.11 Intel Server Platform Services
- 5.4.12 Onboard LAN Configuration
- 5.4.13 MIO Card Configuration
- 5.4.14 Serial Port Console Redirection
- 5.4.15 Runtime Error Logging Support
- 5.4.16 APM
- 5.4.17 Network Stack
- 5.4.18 Intel RC Drivers Version Detail
- 5.5 Event Logs menu
- 5.6 Boot menu
- 5.7 Monitor menu
- 5.8 Security
- 5.9 Tool menu
- 5.10 Exit menu
- Chapter 6: RAID configuration
- Chapter 7: Driver installation
2-19ASUS TS300-E8-RS4-C
2.6.5 Removing and reinstalling the backplane
DO NOT remove the backplane unless necessary!
4. Firmly hold the backplane, lift it
upwards. and remove it from the
module.
5. Follow the previous instructions in
reverse to reinstall the backplane.
6. Push the tray lever until it clicks
and secures the drive tray in place.
The drive tray is correctly placed
when its front edge aligns with the
bay edge.
7. Repeat steps 1 to 6 if you wish to
install another SATAII/SAS drive.
1. Remove all hot-swap HDD trays
from the chassis.
2. Disconnect all cables from the
SATA/SAS backplane.
3. Loosen the four screws on the
backplane.