Owner manual
Table Of Contents
- 1.7 LED information
- 1.6 Internal features
- 1.5 Rear panel features
- 1.4 Front panel features
- 1.3 System specifications
- 1.2 Serial number label
- 1.1 System package contents
- About this guide
- Safety information
- Notices
- Chapter 2: Hardware setup
- Chapter 3: Installation options
- Chapter 4: Motherboard Info
- Chapter 5: BIOS setup
- 5.1 Managing and updating your BIOS
- 5.2 BIOS setup program
- 5.3 Main menu
- 5.4 Advanced menu
- 5.4.1 CPU Configuration
- 5.4.2 PCH-IO Configuration
- 5.4.3 SATA Configuration
- 5.4.4 System Agent (SA) Configuration
- 5.4.5 PCI Subsystem Settings
- 5.4.6 USB Configuration
- 5.4.7 TPM
- 5.4.8 ACPI Settings
- 5.4.9 WHEA Support
- 5.4.10 NCT6779D Super IO Configuration
- 5.4.11 Intel Server Platform Services
- 5.4.12 Onboard LAN Configuration
- 5.4.13 MIO Card Configuration
- 5.4.14 Serial Port Console Redirection
- 5.4.15 Runtime Error Logging Support
- 5.4.16 APM
- 5.4.17 Network Stack
- 5.4.18 Intel RC Drivers Version Detail
- 5.5 Event Logs menu
- 5.6 Boot menu
- 5.7 Monitor menu
- 5.8 Security
- 5.9 Tool menu
- 5.10 Exit menu
- Chapter 6: RAID configuration
- Chapter 7: Driver installation
Chapter 2: Hardware setup2-18
2. Firmly hold the tray lever and pull
the drive tray out of the bay.
3. Take note of the drive tray holes.
Each side has three holes to t
different types of hard disk drives.
Use two screws on each side to
secure the hard disk drive.
4. Place a SATAII/SAS hard disk drive
on the tray, and then secure it with
four screws.
5. Carefully insert the drive tray and
push it all the way to the end of the
bay until just a small fraction of the
tray edge protrudes.
When installed, the SATAII/SAS connector on the drive connects to the SATAII/
SAS interface on the backplane.