Owner manual
Table Of Contents
- 1.7 LED information
- 1.6 Internal features
- 1.5 Rear panel features
- 1.4 Front panel features
- 1.3 System specifications
- 1.2 Serial number label
- 1.1 System package contents
- About this guide
- Safety information
- Notices
- Chapter 2: Hardware setup
- Chapter 3: Installation options
- Chapter 4: Motherboard Info
- Chapter 5: BIOS setup
- 5.1 Managing and updating your BIOS
- 5.2 BIOS setup program
- 5.3 Main menu
- 5.4 Advanced menu
- 5.4.1 CPU Configuration
- 5.4.2 PCH-IO Configuration
- 5.4.3 SATA Configuration
- 5.4.4 System Agent (SA) Configuration
- 5.4.5 PCI Subsystem Settings
- 5.4.6 USB Configuration
- 5.4.7 TPM
- 5.4.8 ACPI Settings
- 5.4.9 WHEA Support
- 5.4.10 NCT6779D Super IO Configuration
- 5.4.11 Intel Server Platform Services
- 5.4.12 Onboard LAN Configuration
- 5.4.13 MIO Card Configuration
- 5.4.14 Serial Port Console Redirection
- 5.4.15 Runtime Error Logging Support
- 5.4.16 APM
- 5.4.17 Network Stack
- 5.4.18 Intel RC Drivers Version Detail
- 5.5 Event Logs menu
- 5.6 Boot menu
- 5.7 Monitor menu
- 5.8 Security
- 5.9 Tool menu
- 5.10 Exit menu
- Chapter 6: RAID configuration
- Chapter 7: Driver installation
7-2
Chapter 7: Driver installation
7.1 RAID driver installation
After creating the RAID sets for your server system, you are now ready to install an
operating system to the independent hard disk drive or bootable array. This part provides the
instructions on how to install the RAID controller drivers during OS installation.
7.1.1 Creating a RAID driver disk
The system does not include a oppy drive. You have to use a USB oppy drive when
creating a SATA RAID driver disk.
If you have created RAID sets with the LSI Software RAID conguration utility, the boot
priority of the SATA optical disk drive has to be manually adjusted. Otherwise, the system
will not boot from the connected SATA ODD.
A oppy disk with the RAID driver is required when installing Windows
®
or Red Hat
®
Enterprise operating system on a hard disk drive that is included in a RAID set. You can
create a RAID driver disk in DOS (using the Makedisk application in the support DVD).
To create a RAID driver disk in DOS environment:
1. Place the motherboard support DVD in the optical drive.
2. Restart the computer.
3. Enter the BIOS Setup.
4. Select the optical drive as the rst boot priority to boot from the support DVD. Save
your changes.
5. Exit the BIOS Setup and restart the computer.
The following Makedisk menu appears.
6. Select the
C22x INTEL RAID Driver
and press <Enter> to go to the sub-menu.
Create Driver Diskette Menu
C22x INTEL RAID Driver
Write DMI
FreeDOS command prompt
7. From the Makedisk sub-menu, use the Up or Down arrow keys to select the driver and
press <Enter> to create the RAID driver disk.
C22x INTEL RAID Driver
C22x INTEL RAID Driver
Windows 32 bit(also support AHCI)
Windows 64 bit(also support AHCI)
Back
Exit