User Guide

4-16
第四章：BIOS 程序設置
4.4.3 SATA 設置（SATA Configuration）
當進入設置畫面時，BIOS 會自動檢測當前現有的 SATA 設備。若該 SATA
Port 項目顯示為 Not Present，則表示對應的該接口並未連接 SATA 設備。
SATA Controller(s) [Enabled]
啟用或關閉 SATA 設備。設置值有：[Enabled] [Disabled]
SATA Mode Selection [AHCI]
本項目提供選擇 SATA Controller(s) 所採用的運行模式。設置值有：
[AHCI ] [IDE] [RAID]
S.M.A.R.T. Status Check [Enabled]
提供開啟或關閉自動檢測、分析、報告技術（Smart Monitoring, Analysis,
and Reporting Technology）。當讀/寫硬盤數據發生錯誤時，這項功能允
許在 POST（開機自檢）時回報警示信息。設置值有：[Enabled] [Disabled]
Aptio Setup Utility - Copyright (C) 2013 American Megatrends, Inc.
Advanced
Control Detection of
the Azalia device.
Disabled = Azalia will be
unconditionally disabled
Enabled = Azalia will be
unconditionally Enabled
Auto = Azalia will be
enabled if present,
disabled otherwise.
PCH Azalia Conguration
Azalia [Auto]
PCH Azalia Configuration
提供您控制檢測 Azalia 設備。設置值有：[Auto] [Disabled]
Aptio Setup Utility - Copyright (C) 2013 American Megatrends, Inc.
Advanced
SATA Controller(s) [Enabled]
SATA Mode Selection [AHCI]
S.M.A.R.T. Status Check [Enabled]
Serial ATA Port 0 HardDisk (250.0GB)
Software Preserve SUPPORTED
Port 0 [Enabled]
Hot Plug [Enabled]
SATA Device Type [Hard Disk Drive]
Spin Up Device [Disabled]
Serial ATA Port 1 HardDisk (250.0GB)
Software Preserve SUPPORTED
Port 1 [Enabled]
Hot Plug [Enabled]
SATA Device Type [Hard Disk Driver]
Spin Up Device [Disabled]
Serial ATA Port 2 HardDisk (250.0GB)
Software Preserve SUPPORTED
Port 2 [Enabled]
Hot Plug [Enabled]
SATA Device Type [Hard Disk Driver]
Spin Up Device [Disabled]
Enable or disable
SATA Device.