User Guide

4-16
Chapter 4: BIOS Setup
4.4.3 SATA Configuration
WhileenteringSetup,theBIOSautomaticallydetectsthepresenceofSATAdevices.The
SATA Port items show Not Present if no SATA device is installed to the corresponding SATA
port.
SATA Controller(s) [Enabled]
This allows you to enable or disable the SATA Device.
Congurationoptions:[Enabled][Disabled]
SATA Mode Selection [AHCI]
This allows you to choose how SATA controller(s) should operate.
Congurationoptions:[AHCI][IDE][RAID]
S.M.A.R.T. Status Check [Enabled]
Self-Monitoring,Analysis,andReportingTechnology(S.M.A.R.T.)isamonitorsystem.When
read/writeofyourharddiskerrorsoccur,thisfeatureallowstheharddisktoreportwarning
messages during the POST.
Congurationoptions:[Enabled][Disabled]
Aptio Setup Utility - Copyright (C) 2014 American Megatrends, Inc.
Advanced
Control Detection of the
Azalia device. Disabled =
Azalia will be unconditionally
disabled Enabled = Azalia will
be unconditionally Enabled
Auto = Azalia will be
enabled if present, disabled
otherwise.
PCH Azalia Conguration
Azalia [Auto]
PCH Azalia Configuration
Allows you to control the detection of the Azalia device.
Congurationoptions:[Auto][Disabled]
Aptio Setup Utility - Copyright (C) 2014 American Megatrends, Inc.
Advanced
SATA Controller(s) [Enabled]
SATA Mode Selection [AHCI]
S.M.A.R.T. Status Check [Enabled]
Serial ATA Port 0 HardDisk (250.0GB)
Software Preserve SUPPORTED
Port 0 [Enabled]
Hot Plug [Enabled]
SATA Device Type [Hard Disk Drive]
Spin Up Device [Disabled]
Serial ATA Port 1 HardDisk (250.0GB)
Software Preserve SUPPORTED
Port 1 [Enabled]
Hot Plug [Enabled]
SATA Device Type [Hard Disk Driver]
Spin Up Device [Disabled]
Serial ATA Port 2 HardDisk (250.0GB)
Software Preserve SUPPORTED
Port 2 [Enabled]
Hot Plug [Enabled]
SATA Device Type [Hard Disk Driver]
Spin Up Device [Disabled]
Enable or disable SATA
Device.