User Guide

ASUS TS100-E9-PI4
3-15
14. Chassis intrusion connector (2-pin INTRUSION1)
 Thisconnectorisforachassis-mountedintrusiondetectionsensororswitch.Connect
oneendofthechassisintrusionsensororswitchcabletothisconnector.Thechassis
intrusionsensororswitchsendsahigh-levelsignaltothisconnectorwhenachassis
componentisremovedorreplaced.Thesignalisthengeneratedasachassisintrusion
event.
 Bydefault,thepinlabeled“ChassisSignal”and“Ground”areshortedwithajumper
cap.Removethejumpercapsonlywhenyouintendtousethechassisintrusion
detection feature.
15. System Management Bus (SMBUS) connector (5-1 pin SMBUS1)
 Thisconnectorcontrolsthesystemandpowermanagement-relatedtasks.This
connectorprocessesthemessagestoandfromdevicesratherthantrippingthe
individualcontrollines.